WALL MOUNT QUARTZ INFRARED ELECTRIC HEATER QWH2100 Operator's Manual WARNING! IF THE INFORMATION IN THIS MANUAL IS NOT FOLLOWED EXACTLY, A FIRE MAY RESULT CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS OR LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER ELECTRIC APPLIANCE Made in China Comfort Home Products, Inc. 12256 William Penn Hwy, Ste A Huntingdon, PA 16652 DURA HEAT PHONE NUMBER: (814) 643-1775 http://www.worldmkting.
IMPORTANT INSTRUCTIONS Read all instructions in this guide before using your Heater. This product is intended for indoor residential, office and personal shop use only, not for industrial or other commercial applications. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. If you have any questions whether your wiring is adequate, consult a qualified electrician.: 1. Read all instructions before using this heater. 2. This heater is hot when in use.
ALWAYS OBSERVE THESE SAFETY PRECAUTIONS WHEN OPERATING YOUR ELECTRIC HEATER ALWAYS Read all instructions before operating. ALWAYS Locate your electric heater away from furniture or loose hanging drapes. ALWAYS Keep the grill away from walls or drapes so as not to block the air intake. (If applicable) ALWAYS Unplug electric heater when not in use. ALWAYS Use this heater in a correctly installed position. ALWAYS Route the cord so it will not be walked on tripped over or pinched by furniture.
SPECIFICATIONS Voltage Heating Power Dimensions Weight Grounded Outlet Over-Heat safety feature IMPORTANT 120V AC 60HZ; 1500 Watts/12.5 Amps 17.32” Wide x 4.49” Deep x 19.21” High 10.6 Lbs This heater is equipped with a Ground Fault Circuit Interrupter (GFCI), a safety feature that renders it inoperable under some abnormal conditions, such as immersion in water. To make sure the GFCI is functioning properly, perform the following test at 120VAC 60Hz frequency. 1. Plug in heater and turn on.
INSTALLATION MINIMUM CLEARANCES TO COMBUSTABLES LEFT/RIGHT TOP BOTTOM FRONT REAR *12 Inches 39 Inches 39 Inches 39 Inches 0 Inches Top clearance is from top of the heater to ceiling or other combustible material Bottom clearance is from the bottom of heater to surface of carpet, tile or other combustible material. * A sidewall must be at least 18 Inches away from the side of heater. -Always maintain a 36 Inch clearance from any furniture, draperies or other combustible material.
INSTALLATION Step 1 (Figure 1) DRY WALL: Using the screws and wall anchors provided install into drywall as shown. Check to insure screws are secure. STUD WALL: Using the screws provided install into drywall as shown. Check to insure screws are secure. CONCRETE WALL: Drill ¼ inch holes, insert # 12 wall anchors (not included) and secure to wall with #12 x 3 inch screws (not included). Check to insure screws are secure. Figure 1 Step 2 (Figure 2) Hook the heater into position.
Requires 2 AAA batteries not included 1. Digital display: Indicates temperature or time. 2. High Mode indicator light: Will be lit when High Heat mode is engaged. 3. Low Mode indicator light: Will be lit when Low Heat mode is engaged. 4. Energy-saving mode indicator: Will be lit when energysaving mode is engaged. 5. °C/°F Button: Alternates between Fahrenheit and Celsius. 6. Mode button to select between High, Low and Eco modes. 7. Temp down button: To decrease desired temperature. 8.
OPERATION 1. Turn Main Power switch on rear of appliance to On. Main Power Switch 2. Start and select working mode Turn the heater on by pressing the ON/OFF button on the control panel or by pressing the Power button on the supplied remote control. Once power is off, heating element will stop working at first. Fan will prolong working for 3 min to emit plenty of heat inside. This mark will indicate running during the 3 min.
3. Setting Desired Temperature Or Adjust the desired temperature by pressing the Up/Down arrows on the control panel or remote control. Or Or Or Desired temperature options vary from 59°F to 86°F,or from 15°C to 30°C Once you have chosen the desired temperature, the heater will remain on until the room temperature increases to the temperature on the digital display. The heater will cycle on and off to maintain the desired room temperature.
The digital display changes from the “temperature” to the “hours” option for the timer. Continue to press the timer button to change the number of hours you would like the heater to run before powering itself off .The hour options for the timer are from 0 to 12 hrs. (in 1 hr increments). The selected hour increments will flash for a few seconds, then revert back to the set desired temperature .The Timer indicator light will remain lit as long as the Timer is set.
CARE AND MAINTENANCE • • • • • • • Turn off the power switch in the rear of the unit. Unplug the unit and let it cool completely. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater.
ELECTRIC HEATER WARRANTY LIMITED WARRANTY: A limited warranty is extended to the original purchaser of this heater and warrants against malfunction due to manufacturing defects for a period of (1) one year from the date of retail purchase. Please read and follow all details noted below. CLAIMS HANDLED AS FOLLOWS: 1. WITHIN 30 DAYS OF PURCHASE: Return to the place of purchase. 2. AFTER 30 DAYS AND WITHIN THE 1 YEAR WARRANTY PERIOD: Contact our Customer Service Team at 1-800-776-9425.
LIMITATIONS: This warranty does not imply or assume any responsibility for consequential damages that may result from the use, misuse, or the lack of routine maintenance of this heating appliance. A cleaning fee and the cost of parts may be charged for appliance failures resulting from lack of maintenance. This warranty does not cover claims, which do not involve defective workmanship or materials. FAILURE TO PERFORM GENERAL MAINTENANCE (INCLUDING CLEANING) WILL VOID THIS WARRANTY.
MURAL CUARZO calentador eléctrico infrarrojo QWH2100 ¡ADVERTENCIA! SI LA INFORMACION EN ESTE MANUAL no ES SEGUIDA EXACTAMENTE, UN RESULTADO del FUEGO mayo que CAUSA DAÑO de PROPIEDAD, HERIDA O PERDIDA PERSONALES DE la VIDA. PARA SU SEGURIDAD Hencho in China No ALMACENE ni UTILICE GASOLINA ni OTROS VAPORES de FLAMABLE ni los LIQUIDOS EN LA VECINDAD DE ESTE niCUALQUIER OTRO APARATO Instrucciones de instalación y el Manual de Propietario Comfort Home Products, Inc.
INSTRUCCIONES IMPORTANTES POR FAVOR LEA Y GUARDE ESTAS INSTRUCCIONES DE SEGURIDAD Cuando se usan aparatos eléctricos, siempre las precauciones básicas deben ser seguidas para reducir el riesgo de incendio, descarga eléctrica y lesiones a personas, incluyendo las siguientes: 1. Lea todas las instrucciones antes de usar el calentador. 2. Este calentador está caliente cuando está en uso. Para evitar quemaduras, no permita que la piel desnuda toque las superficies calientes.
SIEMPRE OBSERVE que ESTAS MEDIDAS DE SEGURIDAD AL OPERAR SU CALENTADORA ELECTRICA Siempre Lea todas las instrucciones antes de operarlo. Siempre Coloque su calentador eléctrico lejos de los muebles o cortinas colgantes. Siempre Mantenga la parrilla lejos de las paredes o lascortinas para no bloquear la entrada de aire. (Si procede) Siempre Desenchufe el calentador eléctrico cuando no esté en uso. Siempre Use este calentador instalado en una posición correcta.
IMPORTANTE PRESUPUESTO Voltaje Energía de la calefacción Dimensiones Peso Enchufe de conexión a tierra Característica de seguridad del sobrecalentamiento 120V AC 60HZ; 1500 Watts/12.5 Amps 17.32” Wide x 4.49” Deep x 19.21” High 10.6 Lbs Este calentador está equipado con un circuito de falla a tierra (GFCI), una característica de seguridad que hace que ocurran situaciones anormales, tales como la inmersión en agua.
INSTALACIÓN DISTANCIAS MÍNIMAS CON RESPECTO A COMBUSTIBLES IZQUIERDA DERECHA PARTE SUPERIOR PARTE INFERIOR FRENTE PARTE TRASERA *12 Pulgadas 39 Pulgadas 39 Pulgadas 39 Pulgadas 0 Pulgadas El espacio libre superior es desde la parte superior del calentador hasta el techo u otro material combustible El espacio libre inferior es desde la parte inferior del calentador hasta la superficie de la moqueta, los azulejos u otro material combustible.
INSTALACIÓN Paso 1 (Figura 1) PANEL DE YESO: Instale en un panel de yeso tal como se muestra, utilizando los tornillos y los anclajes que se proporcionan. Controle para verificar que los tornillos estén asegurados. PARED DE ENTRAMADO: Usando los tornillos provistos instalar en paneles de yeso como se muestra. Compruebe para asegurar tornillos son seguras.
Requiere 2 pilas AAA no incluidas 1. Pantalla digital:Indica temperatura o la hora. 2. Luz indicadora de modo Alto: Se iluminará cuando el modo Alto de calefacción esté activado. 3. Luz indicadora de modo Bajo: Se iluminará cuando el modo Bajo de calefacción esté activado. 4. Indicador de modo Ahorro de energía: Se iluminará cuando el modo Ahorro de energía esté activado. 5. Botón °C/°F: Alterna entre grados Fahrenheit y Celsius. 6. Botón de modo: Para seleccionar modo Alto, Bajo y Eco. 7.
OPERACIÓN 1. Encienda el interruptor de alimentación principal en la parte posterior del aparato. Interruptor de Alimentación 2. Inicio y selección del modo de funcionamiento Presione el botón de encendido ON/OFF en el panel de control o en el control remoto suministrado para encender el calefactor. Una vez apagado, primeramente dejará de funcionar la resistencia. El ventilador seguirá funcionando durante 3 minutos para suministrar suficiente calor en el interior.
3. Ajuste de la temperatura deseada Presione las flechas hacia arriba o abajo en el panel de control o en el control remoto para establecer la temperatura deseada. Or Or Or Or Las opciones temperaturas varían desde 59℉ a 86℉, o desde 15°C a 30°C. Una vez seleccionada la temperatura deseada, el calefactor permanecerá encendido hasta que la temperatura ambiente alcance la temperatura establecida en el panel digital.
La pantalla digital cambiará de la opción de "temperatura" a "horas" para establecer el temporizador. Siga presionando el botón del temporizador para cambiar la cantidad de horas que desea mantener en funcionamiento el calefactor. Las opciones de horas van de 0 a 12 horas (en incrementos de 1 hora). Los incrementos de horas seleccionadas parpadearán unos segundos, luego volverá a la temperatura deseada establecida.
And Para desbloquear, presione los botones de Subir Temp. y Bajar Temp. simultáneamente durante 3 segundos. Escuchará un pitido. El panel de control y el control remoto se podrán volver a utilizar. CUIDADO Y MANTENIMIENTO • • • • • • • Apague el interruptor de alimentación en la parte posterior de la unidad. Desenchufe la unidad y deje que se enfríe completamente. Para mantener el calefactor limpio, limpie la cubierta exterior con un paño suave y húmedo.
GARANTIA ELECTRICA PORTATIL de CALENTADORA La GARANTIA LIMITADA: Una garantía limitada es extendida al comprador original de esta calentadora y autorizaciones contra falla debido a defectos industriales por un período de (1) un año de la fecha de la compra de la venta al por menor. Lea por favor y siga todos los detalles notados abajo. Los RECLAMOS MANEJARON DE LA SIGUIENTE MANERA: - No REGRESA a COLOCAR DE la COMPRA - Contacta nuestro Departamento de Servicio de Costomer en 1-800-776-9425.
Las LIMITACIONES: Esta garantía no implica ni asume responsabilidad para daños consecuentes que pueden resultar del uso, del maltrato, o de la falta de mantenimiento rutinario de este aparato de la calefacción. Un honorario de limpieza y el costo de partes pueden ser cargados para fracasos de aparato que resultan de la falta de mantenimiento. Esta garantía no cubre reclamos, que no implican habilidad ni materiales defectuosos.