Troubleshooting Guide

~ 11 ~
CARE AND MAINTENANCE
• Turn off the power switch in the rear of the unit.
• Unplug the unit and let it cool completely.
• To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a mild detergent
if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT let liquid enter the heater.
• DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the heater. This
may cause damage or deterioration to the surface of the heater.
• DO NOT immerse the heater in water.
• Wait until the unit is completely dry before use.
• If you do not use the heater for a long time, please take out the remote batteries (to prevent corrosion ) as
shown below. Store the remote in a safe place.
TROUBLE SHOOTING
\
PORTABLE ELECTRIC HEATER WARRANTY
PROBLEM
CORRECTIVE ACTION
1. Heater does not blow warm air
a. The room temperature is higher than the thermostat setting.
b. Check to be sure unit is on high setting.
c. If the power button on the front of the heater is red but the heater is
not operating the safety overheat function may have been triggered. Try
pressing the power button. If the heater does not turn on, clear any
obstructions from front and rear of unit that may have caused internal
overheating. Allow the heater to cool for approximately 10 minutes and
then press the power button again.
2. No Power to heater
a. Make sure main switch on rear of unit is switched to on position.
b. Over heat safety control activated. Remove blockage from filter and
around heater. Unplug heater for 10 to 20 minutes. Unit should then
operate normally.
c. Check circuit breaker, reset as needed or plug into different outlet.
d. Call customer service at 1-814-643-1775 or visit us at
www.worldmkting.com