Use and Care Manual

5
CLEANING THE TANK
Put 1/2 teaspoon of chlorine bleach and 1/2 gallon of water in the tank. Let
solution set for about 20 minutes swishing every few minutes. Empty the tank and
rinse well with water until the bleach odor is gone. Be careful not to splash the
solution on surfaces/clothing that may get damaged by the cleaning solution. Do
not operate the humidifier with the chlorine bleach solution in the tank.
CLEANING THE TRAY
From time to time mineral deposits will accumulate in and on the water basin.
When this occurs, the water basin should be cleaned.
END OF SEASON CARE AND STORAGE
Empty the tank and tray of water. Clean all surfaces with a damp, soft cloth.
When completely dry, store the humidifier in its original carton, in a cool, dry,
clean location. Remember to clean and inspect your humidifier before using it the
next season.
Common Troubleshooting Methods
Abnormal
symptom
Cause
Solution
Indicator not
illuminated with
no air and no
mist
• The power cord is not
properly plugged in or
the power switch is not
turned on
• Plug the power cord
properly into a working
outlet, turn on the power
switch
Indicator
illuminated with
air and no mist
• There is no water in the
water tank
• The Mist Control Dial is
not turned up
• The water level float cap
is not down releasing
water
• Fill up the water tank
• Turn Mist Control Dial
clockwise
• Confirm the water tank
spring float cap is not
stuck
Indicator is
illuminated with
no air or no fog
• The water level in the
water bath is too high
• Remove some water in
the unit’s water basin
• Screw down the water
tank spring float cap
Reduced mist
output
• There is scale formation
on the transducer
• The water is dirty or has
been stored too long
• Clean the water basin and
inlets
• Replace with clean water