Use and Care Manual

ManualsBrandsComfort Zone ManualsFansPowrCurve 18 in. Pedestal Fan

Save These Instructions

www.comfortzoneproducts.com

Features:

• 2-In-1 Fan Design: Stand or Wall-Mountable

• Push-Button Control with 3 Speed Settings

• Tri-Curve Plastic Safety Grille

• 6 Fan Blades

• Adjustable Tilt Head

• Wide Area Oscillation

• Adjustable Stand up to 53in. Height

• 120V A.C. / 60Hz

CZST180 Series

POWR CURVE TECHNOLOGY

with its 6-blade fan design has

30% higher airow for maximum

cooling.

The TRIPLE-ZONE tri-curve grille

eliminates turbulence for a stronger

airow with 20% less noise!*

*Note: Compared to a non-curved fan grille

18" Turbo Performance

Stand Fan

WALL

Summary of content (6 pages)

PAGE 1
POWR CURVE TECHNOLOGY with its 6-blade fan design has 30% higher airflow for maximum cooling.
PAGE 2
www.comfortzoneproducts.com INTENDED USE: This product is intended for indoor residential and office use only, not for industrial or other commercial applications. Use only with electrical wiring that is in good working order and that meets applicable codes and ordinances. If you have any questions whether your wiring is adequate, consult a qualified electrician. While using your fan, you should follow the IMPORTANT INSTRUCTIONS listed below.
PAGE 3
www.comfortzoneproducts.com PARTS IDENTIFICATION 3 1. Front grille 2. Rear grille 3 1 3. Grilles’ clips 2 4 4. ST 3x8mm Screw with washer top: (secures rear grille to motor cover) 5. M3x20 Screw and M3 Nut (secure grilles' interlock) 6 5 6. Fan blades 9 10 8 5 11 7 7. Blades nut 12 8. Motor shaft Step 2: Using a Philips-head screwdriver, screw the 3x8mm screew with washer top (included in the parts kit) into the cylinder-shaped housing at the top of the grille (Fig. 2). Fig.
PAGE 4
www.comfortzoneproducts.com STAND FAN ASSEMBLY: WALL MOUNTING Base Assembly: This fan comes with a wall mounting option. Step 1: Unscrew the L-screw from the telescopic tube washer and set the tube inside the base's round hole (Fig. 1). Note: It is not recommended to install the fan support bracket on prefabricated walls or unstable walls. The fan should be level when mounted and at least one of the two mounting screw locations should be a wall stud. Fig.
PAGE 5
www.comfortzoneproducts.com Oscillation Switch: CARE AND MAINTENANCE The oscillation control knob may not be attached when the fan is first removed from the box. To attach, locate the oscillation control knob inside the plastic bag that contains the parts of the Knob fan. Insert the oscillation control knob inside the engine body hole assigned for it and push down firmly until a “click” sound is heard. Make sure the oscillation control knob is correctly assembled.
PAGE 6
www.comfortzoneproducts.com LIMITED WARRANTY This unit is guaranteed to the original retail purchaser against defects in quality or workmanship for a period of one year from the date of original purchase. If this unit fails because of a manufacturing defect within 30 days of purchase, return the unit, with your receipt, to the retailer.