Use and Care Manual
4
4
www.comfortzoneproducts.com
Step 1:
• Using a 1/4-in drill bit, drill two
horizontally aligned holes in the
wall with 1.5-inch separation
between them.
• Push a 1/4-inch plastic anchor
(included) in each hole.
• Insert a 1/4-inch x 1-inch screw
(included) in each anchor and
screw it into the anchor body no
more than 0.78 inches deep
(Fig. 1 ).
Step 2:
Set the previously assembled
motor body with the fan head onto
the wall fan support bracket (Fig. 2)
and tighten it from behind with the
xing knob (Fig. 2a).
Step 3:
Mount the bracket
with fan on the
previously set two
wall screws (Fig. 3)
and make sure it is
set properly (Fig. 3a).
STAND FAN ASSEMBLY:
Base Assembly:
Mounting the Fan on the Base:
Step 1:
Unscrew the L-screw from the
telescopic tube washer and set
the tube inside the base's round
hole (Fig. 1).
Step 2:
Place the counterweight at the
bottom of the base. Set the
washer under the counterweight
so that the dome piece touches
the counterweight (Fig. 2).
Step 3:
Screw the L-screw clockwise into
the washer, holding the telescopic
tube until it is tight into the base
(Fig. 3).
Step 1:
• Loosen the height xing ring (A)
located on the telescopic tube
by turning it counterclockwise
and lift the telescopic pole until it
reaches the desired height.
• Screw the ring (A) clockwise
until it is tight enough to secure
the telescopic pole hight.
Step 2:
Unscrew the xing knob (B) and
t the telescopic pole inside the
motor body. Make sure to reach
the bottom of the engine body
base and screw the xing knob
clockwise until it is tight.
This fan comes with a wall
mounting option.
Note: It is not recommended to
install the fan support bracket on
prefabricated walls or unstable
walls. The fan should be level
when mounted and at least one of
the two mounting screw locations
should be a wall stud.
WALL MOUNTING
Fig. 1
Fig. 2
Fig. 2a
Fig. 3aFig. 3
Fig. 3
Fig. 1
Fig. 2
Stand Fan
Assembled
Wall-mounted
Fan
WALL
NOTE: The pedestal extension
pole may be recessed inside
the larger pole of pedestal
body.
A
B