Owner`s manual

- 14 -
Version: May 2011
and drain to a suitable place.
Important!
Cleaning the Filter
1. Unplug the power pack from the
electrical outlet.
2. Using the three caps provided,
cap the suction and discharge fittings
on the inside of the spa.
3. Open the air bleed fitting on the
top of the filter tank.
4. Unscrew the retainer ring from the
filter housing and remove the filter
housing cover.
5. Lift the filter out of the filter
housing. Clean the filter with the
spray from a high pressure garden
hose.
6. Place the filter back in the filter
housing. Make sure the filter is
properly seated in the housing and
that the o-ring is properly seated in
the o-ring groove.
Note: Ensure that the central post
and ring on the underside of the
cover aligns and fits fully into the top
of the filter. Failure to do so may
result in water leaks from the filter
housing and/or power pack during
operation.
7. Install the filter housing cover and
secure with the retaining ring.
Tighten the retaining ring hand tight.
Do not over tighten the retaining ring.
8. Remove the caps from the spa
suction and discharge fittings inside
the spa.
Meijer.com