Installation Guide

Operator’s Manual
HP54 Pellet Stove
~ 29 ~
SET Blower
Select the “set Blower”, and press enter. This will take you
into the “Set Blower” screen. SEE FIGURE 36.
Set Blower
Blower :ON
Figure 36
You can set Blower off only when the pellet stove
have dual convection constructions: natural convection
and Blower convection.
RESET
Select the “Reset”, and press enter. This will take you into the
“Reset” screen. SEE FIGURE 37.
Reset
Are you sure to reset? yes
Figure 37
If at any time you desire to return your controlled stove settings
to their original state, (i.e. rest blower voltage levels or weekly
schedules) your stove does have the ability to restore the
default settings.
SHUT DOWN PROCEDURE
Press the button on the control pad to initiate the
shut down mode. The On/Off indicator on the screen will
read OFF. The auger will stop feeding pellets, but the room air
distribution blower and exhaust fan will continue to operate.
Once the stove has cooled down, the screen light will turn off.
Alarm Messages
All alarm messages are showed as below. (figure 38).
Display at the
stove
Action to be taken
Lost connect
Check if the plug of data cable is
loose
Ignite failure
1.Check if Pellet fall into
burnpot
2.check if ignitor work properly
3.check if exhaust fan stop or
door is not close
Low Temperature
Check if Hopper is empty
High Temperature
Check if feeding is abnormal
Figure 38
WARNING
NEVER SHUT THE STOVE DOWN BY UNPLUGGING
IT FROM THE POWER SOURCE.
NEVER SHUT THE STOVE DOWN BY SWITCHING
OFF THE MAIN POWER SWITCH ON THE REAR OF
THE STOVE.