Specifications

26For more information and disclaimer, visit www.jabra.com
ELECTRONIC HOOK SWITCH (EHS) SOLUTIONS FOR SNOM
To connect your Snom phone and Jabra head-
set with the Snom-cable, just follow these
simple steps:
SETTING UP THE SNOM PHONE
Setting up Jabra PRO™ 9400 and
Jabra GO™ 6470 – follow the guide on page 31.
SETTING UP JABRA PRO™ 920
1. Connect the Jabra LINK™ adapter as shown
in adapter documentation supplied with
the Jabra LINK™. On some phones the
telephone cable will also need to be
connected.
2. Call your connected desk phone using
another phone to enable the Jabra LINK™
adapter. Wait 10 seconds before answering.
3. Set a clear dial tone. Locate the clear dial
tone switch on the back of the Jabra PRO
920 base and rotate to “A”.
4. Set the Microphone volume. Make a call
to test your speaking volume. The listener
should not adjust their own volume. You
may adjust your microphone speaking
volume using the + / - volume buttons.
SETTING UP JABRA GN9350e
1. Open up the cover on the base unit.
2. On the LCD display, navigate to the handset
picture.
3. Navigate to the DHSG mode and select it by
pressing the OK button.
4. Set Compatibility selector in position “A” .
Compatibility selector
Jabra GN9350e
SETTING UP JABRA GN9330e
1. Place the headset in the base with its
indicators facing you.
2. Press the Telephone
button on the Base for
6 seconds while the
headset is in the base until
the headset’s blue LED is
flashing rapidly.
3. Use the volume up/down
button to shift between
the different EHS settings
– see table below.
The base unit’s 4 battery indicators show
which EHS mode the Jabra GN9330e is in.
25 %
100 %
GN RHL (Default)
DHSG
AEI
MSH
Note: If more than 15 seconds elapse without
pressing the volume + or volume – button, the
last selected interface will be activated.
4. Set the base unit to the DHSG mode.
5. To set the EHS mode, press the Telephone
button on the Base for 6 seconds until the
4 battery indicators flash once. Now wait 5
seconds and the headset is initialized.
6. Set Compatibility selector in position “A”.
SETTING UP JABRA GN9120/
JABRA GN9125
1. Set Compatibility selector ( Telephone
Termination Switch Wheel ) in position “A”.
2. Set the base unit to the DHSG mode by
keeping the headset in the base and hold
the volume + / - buttons on the headset for
6 seconds until the red light on the base
flashes rapidly.
3. Scroll through the four different settings
using + / - and set to the lips icon. Leave for
15 seconds until the unit has displayed the
confirmation flash sequence and it is ready
to go!
SET UP INFORMATION