User manual

2 of 17
IMPORTANT! Please inspect immediately upon receipt!
Check unit immediately for any transportation damage.
Any claim for damage that is received too late cannot be asserted against the transport insurance.
Please also connect the unit and open the mirror flap over the switch or RS232 in order to check the mirror
for hidden damage. For this purpose, the ProFLECT II i must be placed upside down for the flap to tilt up
freely. After checking, close the mirror flap via the switch or RS232.
Check that the box contains all parts listed below:
1 piece ProFLECT II i ceiling mirror consisting of frame, linear electrical drive mechanism,
small mirror incl. mount, power supply and electronic circuit with terminal/RS232
connection,
Mirror flap with large mirror and projector plate
1 set Hex bolt for small mirror (additional 8 pieces)
1 piece User manual
Installation Notice
Warning:
 The mirrors are high-quality surface glass mirrors!
 Avoid touching the mirrors with your fingers!
 Do not use unsuitable cleaning agents and cleaning clothes!
 Remove dust with purified compressed air.
The surface mirrors are covered with a protective foil. Only remove if absolutely necessary! For additional
protection, use e.g. cardboard or thin plywood in order to prevent damage caused by falling tools or other
parts.
If the foil has already been removed, always protect the mirror when adjusting or maintaining the
ProFLECT II i. Make sure that the mirror surface cannot be scratched by the cover.