User's Manual

4) Level your towable vehicle from side-to-side
As noted above, when leveling your vehicle from side-to-side you will be using
the top section of the Leveling screen. When the vehicle is not in a level position,
there will be a yellow arrow pointing upward on one side of the trailer graphic
front view. This indicates which side of the vehicle needs to be raised to achieve
a level position from side-to-side. The displayed measurement indicates how
much height will be required on the side where the arrow is displayed. Stack
your leveling blocks to the height indicated by the displayed measurement and
place the blocks in the front or rear of the tire(s) on the side indicated by the
arrow. Then move your vehicle so that the tires are on top of the blocks and
check the level indicator displayed over the measurement distance. If you have
achieved a level position, the level indicator will be green and the displayed
measurement distance will be ‘0’ as in figure 10. If the level indicator is red and
the displayed measurement distance is not ‘0’, then note the measurement
distance and move the vehicle tire(s) off the blocks and add or remove blocks
equaling the measurement distance that was displayed when the tire(s) were on
the blocks. Once again, move the vehicle tire(s) onto the blocks and check the
level indicator and measurement distance to insure that the vehicle is now level
from side-to-side.
NOTE: The reason adding blocks for a second leveling attempt (as
mentioned above) may be required would be due to soft ground that allows
the blocks to sink slightly into the ground or that the location the blocks
were placed was slightly different than where the initial height requirement
measurement was taken. To avoid issues with the blocks being positioned
at a slightly different location than where the initial height requirement
measurement was taken, simply make a note of the height required at the
desired parking location. Then move your vehicle a foot or two from that
position so you can place the blocks at the same location as the initial
height requirement measurement was taken.
5) Save your hitch position (towable vehicles only)
If the vehicle you are leveling is a trailer, you will need to disconnect it from your
tow vehicle before leveling it from front-to-back. Release your hitch from the tow
vehicle and extend the jack on the trailer until the hitch is just above the ball or
hitch plate (in the case of a 5th wheel hitch). At the bottom left of the Leveling
screen, tap on the Save Hitch Position button. This will record the current
position of the trailer hitch. This saved position can be used to return the hitch to