User Manual

1
To Remove
IMPORTANT: Failure to follow instructions carefully may cause damage!
SAVE INSTRUCTIONS for damage-free removal or visit command.com
NEVER pull strip
towards you.
Hold clip gently to prevent
clip from snapping fingers.
DO NOT press clip
against wall.
STRETCH STRAIGHT
DOWN ALONG WALL
AT LEAST 6 INCHES
(15 cm) until strip
releases from wall.
2
1
STRAIGHT
DOWN
3
6"
15 cm
17026CLR
command.com
To Apply
PRESS FIRMLY along the
entire clip for 30 seconds.
Wait 1 hour before use.
Remove BLUE Liner and
apply clip to strip. Make
sure tab is accessible for
future removal.
Remove BLACK “Wall side”
Liner and apply strip to
desired location. PRESS
FIRMLY along the entire
strip for 30 seconds.
Best for SMOOTH
SURFACES. CLEAN surface
with rubbing alcohol, wipe
gently, let dry. Do not use
household cleaners.
SEPARATE strips.
BLUE
SIDE
31 2
30
SECONDS
30
SECONDS
4
The following statements only apply to products distributed in the USA.
Limited Warranty:
This 3M product will be free from defects in material and manufacture.
If this product is defective, your exclusive remedy shall be, at 3M’s
option, replacement of the product or refund of the purchase price.
Limitation of Liability:
3M will not be liable for any loss or damage arising from this product,
whether direct, indirect, special,
incidental or consequential.
For questions, ideas and special offers go to command.com
Not intended for picture hanging.
Instead use Command
™
Picture
Hanging Strips, Sawtooth or
Wire-Backed Hangers.
Clips can be reused with
Command
™
Mini Clear Strips.
NOTE:
Apply to surfaces above 50°F
(10°C). Adhesive could lose
adhesion above 105°F (40°C).
CAUTION:
DO NOT use on windows
or with wallpaper. May not
adhere well to vinyl surfaces
or textured surfaces. DO NOT
use for antiques, heirlooms,
or other valuable or
irreplaceable items. DO NOT
hang items over beds. Use
only one clip per item hung.