Use and Care Manual

ENGLISH
Page 14
SET UP & USE
AIR CONDITIONER FEATURES
WARNING: To reduce the risk of re, electric shock, or injury to persons, read the
IMPORTANT SAFETY INSTRUCTIONS before operating this appliance.
CAUTION: Please always wait 3 minutes when turning unit off then on again, and when
changing from cool to fan and back to cool. This prevents compressor from
overheating & possible circuit breaker tripping.
To begin operating the air conditioner, follow these steps:
1. Set the thermostat to the highest number (coldest or cooler setting).
2. Set the selector control to the highest COOL setting.
3. Adjust the louver for comfortable air ow (see Air Directional Louvers).
4. Once the room has cooled, adjust the thermostat to the setting you nd most
comfortable.
5. Make sure that the air ow inside and outside are not obstructed by anything.
AIR DIRECTIONAL LOUVERS
The louvers will allow you to direct the air ow Up or Down (on some models) and Left or
Right throughout the room as needed. Pivot horizontal louvers until the desired Up/Down
direction is obtained. Move the Lever(s) from side to side until the desired Left/Right
direction is obtained.
FRESH AIR VENT CONTROL
The Fresh Air Vent allows the air conditioner to:
1. Recirculate inside air - Vent Closed (See Fig. A)
2. Draw fresh air into the room- Vent Open (see Fig. B)
3. Exchange air from the room and draws fresh air into the room - Vent and Exhaust Open
(see Fig. C)
cord.
LeversLevers Levers
cord.
LeversLevers Levers
Fig. A (VENT CLOSED)
Fig. B (VENT OPEN)
Fig. C (VENT & EXHAUST OPEN))