Instructions / Assembly

4-1/16”
Parts Included
1. One (1) Low Voltage Recessed Cable Plate
Tools Needed
1. Drywall saw
2. 6 Ft. tape measure
3. Pencil
4. Screwdriver
Use CE Tech’s Low Voltage Recessed Cable Plate to install low
voltage cables behind your flat panel TV, (see Figures 2 & 3),
your amplifier or other audio and video devices. These recessed
low voltage cable plates are designed for use with Low Voltage /
Data Cables “ONLY”.
Low Voltage Recessed Cable Plates are designed with the low
voltage mounting brackets molded to the back of the plate (see
Figure 1). The wall plate can be installed upright or upside down
(see Figures 2 & 3 for upright installation).
Determine the location of your flat panel T
V, ampli
fier or
audio/video device. Use the enclosed template to cut a hole in
the drywall. When cutting the hole in the drywall, allow for the
location of the stud. Now simply pull your audio/video cables
through the wall and through the opening in the Low Voltage
Recessed Cable Plate (to help insert larger cables through the
opening in the wall plate, the back scoop of the wall plate is
removable). Now insert the Low V
oltage Recessed
Cable Plate
flush into the wall. Next, screw down the wall plate screws with
wings. The wings will fasten tightly against the back of the drywall
(see Figure 3) and your installation is complete.
These Recessed Cable Plates are Designed for Use
with Low Voltage / Data Cables “ONLY”.
Do Not Run or Pull the TV Cord or Other Electrical
Cords Inside the Drywall. National Electrical Code (NEC)
Does Not Allow the Installation of the TV Power Cord or an
Extension Cord Behind the Wall.
CAUTION
Never install low voltage wiring during lightning storms.
Never install low voltage wiring in wet locations
unless the wire is specifically designed for wet
locations.
Never touch un-insulated low voltage wires or
terminals unless the wire has been disconnected at
its source.
Use caution when installing low voltage cables.
IMPORTANT INSTRUCTIONS
Read and understand all instructions.
Follow all warning and instructions marked on the
product.
Do not use this product near water, for example
near a bath tub, wash bowl, kitchen sink, or
laundry tub, in a wet basement, or near a
swimming pool.
SAVE THESE INSTRUCTIONS.
WARNING
CE Tech’s products shall be installed and used only as
indicated in CE Tech’s product instruction sheets.
Figure 2 - Front View
Instruction / Installation Sheet
Low Voltage Recessed Cable Plate 5018
This product is patent protected by U.S. Patent number 7390964
RoHS Compliant
5018 Rev 2
Figure 1
Figure 3 - Back View
Front View
Back View
Low Voltage Mounting
Bracket Wing
2-5/16”
TEMPLATE
Low Voltage Recessed Cable Plate
5018
ACTUAL SIZE
CUT ALONG DOTTED LINE
Using Template (below),
Cut a Hole in the Drywall
Page 1 of 1
Concealed Low Voltage Wiring
(hidden in wall)
Receiver
Surge Protector
Flat Screen TV
Flat Screen TV
Concealed Low Voltage Wiring
(hidden in wall)
Receiver
Surge Protector

MADE IN CHINA
HECHO EN CHINA
DISTRIBUTED BY
DISTRIBUIDO POR
HOME DEPOT U.S.A., INC.
2455 PACES FERRY RD., N.W.
ATLANTA, GA 30339
FOR ASSISTANCE, CALL:
SI NECESITA AYUDA,
LLAME AL:
1-800-394-7519
HOMEDEPOT.COM