Instructions / Assembly

2-1/4”
Parts Included Tools Needed
1. Flexible Opening Cable Wall Plate 1. Drywall saw
2. 6 Ft. tape measure
3. Pencil
4. Screwdriver
Use the Flexible Opening Cable Wall Plate to install low voltage cables behind
your flat panel TV, (see Figures 2 & 3), your amplifier or other audio and video devices.
This wall plate is designed for use with Low Voltage / Data Cables “ONLY”.
The Flexible Opening Cable Wall Plate is designed with the low voltage mounting brackets molded to the back of the plate (see Figure 1).
Determine the location of your flat panel TV, amplifier or audio/video device. Use the enclosed template to cut a hole in the drywall. When cutting the
hole in the drywall, allow for the location of the stud. Now simply pull your audio/video cables through the wall and through the opening in the Flexible
Opening Cable Wall Plate. Now insert the Flexible Opening Cable Wall Plate flush into the wall. Next, screw down the wall plate screws with wings. The
wings will fasten tightly against the back of the drywall (see Figure 3) and your installation is complete.
This Flexible Opening Cable Wall Plate is Designed for Use with Low Voltage / Data Cables “ONLY”.
Do Not Run or Pull the TV Cord or Other Electrical Cords Inside the Drywall.
National Electrical Code (NEC) Does Not Allow the Installation of the TV Power Cord or an Extension Cord Behind the Wall.
CAUTION
 Never install low voltage wiring during lightning storms.
 Never install low voltage wiring in wet locations unless the wire is specifically designed for wet locations.
 Never touch un-insulated low voltage wires or terminals unless the wire has been disconnected at its source.
 Use caution when installing low voltage cables.
IMPORTANT INSTRUCTIONS
 Read and understand all instructions.
 Follow all warning and instructions marked on the product.
 Do not use this product near water, for example near a bath tub, wash bowl, kitchen sink, or laundry tub, in a wet basement, or near a
swimming pool.
 SAVE THESE INSTRUCTIONS.
Figure 2 - Front View
Instruction / Installation Sheet
Flexible Opening Cable Wall Plate 5028
This product is patent protected
by U.S. Patent number 7495171
RoHS Compliant
5028 Rev 2
Figure 1
Figure 3 - Back View
5028 – Front View
5028 – Back View
4”
CUT ALONG DOTTED LINE 
TEMPLATE
5028
Flexible Opening
Cable Wall Plate
ACTUAL SIZE
Concealed Low Voltage Wiring
(hidden in wall)
Receiver
Surge Protector
Flat Screen TV
Flat Screen TV
Concealed Low Voltage Wiring
(hidden in wall)
Receiver
Surge Protector
Using
Template,
Cut a Hole
in the Drywall
Low Voltage
Mounting
Bracket Wing
Page 1 of 1
MADE IN CHINA
HECHO EN CHINA
DISTRIBUTED BY
DISTRIBUIDO POR
HOME DEPOT U.S.A., INC.
2455 PACES FERRY RD., N.W.
ATLANTA, GA 30339
FOR ASSISTANCE, CALL:
SI NECESITA AYUDA,
LLAME AL:
1-800-394-7519
HOMEDEPOT.COM