Instructions / Assembly

2
Safety Information
WARNING: Carefully read and understand the
information given in this manual before beginning
the assembly and installation. Failure to do so
could lead to electric shock, fire, or other injuries
which could be hazardous or even fatal.
WARNING: Ensure the electricity to the wires you
are working on is shut off. Either remove the fuse
or turn off the circuit breaker.
WARNING: RISK OF FIRE OR ELECTRIC SHOCK.
INSTALLATION OF THIS LED RETROFIT KIT
ASSEMBLY REQUIRES A PERSON FAMILIAR WITH
THE CONSTRUCTION AND OPERATION OF THE
LIGHT FIXTURE’S/LUMINAIRE’S ELECTRICAL
SYSTEM AND THE HAZARD INVOLVED. IF NOT
QUALIFIED, DO NOT ATTEMPT INSTALLATION.
CONTACT A QUALIFIED ELECTRICIAN.
WARNING: INSTALL THIS KIT ONLY IN
LUMINAIRES (LIGHT FIXTURES) THAT HAVE THE
CONSTRUCTION FEATURES AND DIMENSIONS
SHOWN IN THE PHOTOGRAPHS AND/OR
DRAWINGS INCLUDED IN THESE INSTALLATION
INSTRUCTIONS, AND WHERE THE INPUT RATING
OF THE RETROFIT KIT DOES NOT EXCEED THE
INPUT RATING OF THE LUMINAIRE.
WARNING: DO NOT MAKE OR ALTER ANY
OPEN HOLES IN AN ENCLOSURE OF WIRING
OR ELECTRICAL COMPONENTS DURING KIT
INSTALLATION.
WARNING: TO PREVENT WIRING DAMAGE OR
ABRASION, DO NOT EXPOSE WIRING TO EDGES
OF SHEET METAL OR OTHER SHARP OBJECTS.
NOTICE: THE RETROFIT KIT IS ACCEPTED AS A
COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY
OF THE COMBINATION SHALL BE DETERMINED BY
AUTHORITIES HAVING JURISDICTION. PRODUCT
MUST BE INSTALLED BY A QUALIFIED ELECTRICIAN IN
ACCORDANCE WITH THE APPLICABLE AND APPROPRIATE
ELECTRICAL CODES. THE INSTALLATION GUIDE DOES NOT
SUPERSEDE LOCAL OR NATIONAL REGULATIONS FOR
ELECTRICAL INSTALLATIONS.
NOTICE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and the
receiver.
□ Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician
for help.
WARNING: Changes or modifications not
expressly approved by the party responsible for
compliance could void the user’s authority to
operate the equipment.
NOTICE: MINIMUM LAMP COMPARTMENT DIMENSIONS
FOR MODEL # 53803111: 6 INCH DIAMETER X 8 INCH
DEPTH WHEN USED IN A 6-INCH RECESSED LUMINAIRE.
NOTICE: USE ONLY IN OPEN LIGHT FIXTURES/
LUMINAIRES.
NOTICE: SUITABLE FOR TYPE IC OR SUITABLE FOR TYPE
NON-IC.
Table of Contents
T able of Contents..........................................2
Safety Information ........................................ 2
Warranty........................................................3
Pre-Installation ............................................. 3
Planning Installation ..................................3
Tools Required ...........................................3
Package Contents ......................................3
Installation .................................................... 4
Mount to 6 in. Housing with C-Clamps ........ 4
Mount to 6 in. Housing without C-Clamps ...5
Adjusting the Direction & Beam Angle ........7
Care & Cleaning ............................................8
Troubleshooting ............................................8
Light Distribution .......................................... 8