Instructions / Assembly

2
Safety Information
WARNING: Carefully read and understand the information
given in this manual before beginning the assembly and
installation. Failure to do so could lead to electric shock, fire,
or other injuries which could be hazardous or even fatal.
WARNING: Ensure the electricity to the wires you are
working on is shut off. Either remove the fuse or turn off the
circuit breaker.
WARNING: Risk of fire or electric shock. Installation of this
LED Retrofit Kit assembly requires a person familiar with the
construction and operation of the light fixture’s/luminaire’s
electrical system and the hazard involved. If not qualified,
do not attempt installation. Contact a qualified electrician.
WARNING: Install this kit only in luminaires (light fixtures)
that have the construction features and dimensions shown
in the photographs and/or drawings included in these
installation instructions, and where the input rating of the
retrofit kit does not exceed the input rating of the luminaire.
WARNING: Do not make or alter any open holes in an
enclosure of wiring or electrical components during kit
installation.
WARNING: To prevent wiring damage or abrasion, do not
expose wiring to edges of sheet metal or other sharp objects.
NOTICE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harm-
ful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
□ Reorient or relocate the receiving antenna
□ Increase the separation between the equipment and the receiver.
□ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
NOTICE: Minimum lamp compartment dimensions for Model #
53801101: 155 (DIA) mm x 190 (H) mm when used in a 6-inch recessed
luminaire.
NOTICE: Minimum lamp compartment dimensions for Model #
53802101: 110 (DIA) mm x 190 (H) mm when used in a 4-inch recessed
luminaire.
Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Warranty ...................................................3
Pre-Installation .........................................3
Planning Installation ..............................3
Tools Required .......................................3
Package Contents ..................................3
Installation ................................................4
Mount to 6 in. Housing with Ears .............5
Mount to 6 in. Housing without Ears ........6
Mount to 4 in. Housing .............................7
Adjusting the Light Output .......................8
Care & Cleaning ........................................9
Troubleshooting ........................................9
Light Distribution ......................................9