Instructions / Assembly

NOTE: Multiple Commercial Wrap Lights can be connected, up to a maximum of 10 light fixtures. Only the first fixture needs to be directly
wired to an electrical box. Do not exceed 300 total watts for interconnected lights.
□ If planning to continuously mount multiple fixtures using a single power source, feed the electrical wires from
the electrical box through the center of the mounting bracket (AA) and then through the open knock out hole
in the fixture housing (A).
Single
Fixture
Wiring
Continuous
Mount
Wiring
6
Installation (continued)
5
Making the electrical connections
□ Insert the hot and neutral (black and white) wires from the electrical box into the wire connectors of the same
color wires from the housing (A).
□ Insert the ground wire from the electrical box into the wire connector attached to the green wire from the
housing (A).
□ If a 0-10v dimming circuit is available, insert the purple and gray wires from the electrical box into the wire
connectors of the same color wires from the housing (A).
A
B
A
B
AA
AA
AA
AA
4
Feeding the wires
□ Feed the electrical connection wires through any knock out hole and then through the mounting bracket (AA).
A
A