Installation Guide

5 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
1
Installing the U brackets
□ Hold the U brackets (CC) up to the mounting surface to determine the
mounting position.
NOTE: The U brackets (CC) should be positioned 33 inches apart.
□ Mark the screw positions for the U brackets (CC) on the mounting
surface.
□ Drill two 1/8 in. pilot holes into the screw locations marked on the
ceiling. You can also use an awl or nail to dimple the screw holes.
□ Install a drywall anchor (BB) in each drilled mounting hole.
□ Insert two mounting screws (AA) through the U bracket (CC) and into
the drywall anchors (BB) installed in the mounting surface.
□ Tighten each mounting screw (AA) to secure the U bracket (CC) to the
mounting surface.
□ Repeat the installation for the second U bracket (CC).
Surface Mounting
With power disconnected to the electrical box, remove the existing fixture.
Make a sketch of how the current fixture is wired (by wire color or mark
the wires with masking tape and a pencil so you will know how to properly
reconnect the wires to the new LED light fixture. Also,open one side of the
end cap by screwing off the two screws, remove the waterproof connector
and linking cable of the new fixture before the surface mounting.
The continuous mounting steps are based on the suspended
mounting.
□ Open the end cap by screwing off the two screws, remove
the waterproof connector and linking cable, and punch out
the knock out holes (0.86-inch) on the end of each end cap
where the fixtures will connect.
□ Insert a type 1/2 out diameter conduit and nut through
both open knock out holes.
□ Insert one end of the jumper wires (not included) into the
wire connectors from the first fixture, then run jumper
wires through the conduit and nut (not included), and
insert the other end into the wire connectors from the next
fixture to make the electrical connections.
□ Refer to the suspended installation steps to finish the
suspended mounting of all the fixtures.
NOTE:
The Conduit shall comply with UL1660, UL LISTED, liquid
tight, suitable for outdoor use.
The conduit fitting comply with UL514B, UL LISTED,
Liquid-tight, suitable for outdoor use.
Nut: P502-1/2, E256570, Conduit: PLFNCB-1/2,E361947
Multiple light fixture can be connected, up to a maximum
of 8 lights.
knock out hole
end cap
conduit
wirenut
end to end connection
nut
Continuous Suspended Installation
CC
AA
BB
mounting surface