Installation Guide

5 HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
WARNING: Before doing any work on the fixture, disconnect power to the light fixture.
Minor problems often can be fixed without the help of an electrician.
Problem Possible Cause Solution
The fixture will not
light.
The power is off. Ensure the power supply is on.
The circuit breaker is off. Ensure the circuit breaker is in the on position.
There is a bad connection. Check to ensure proper wire connections are made. Contact a qualified electrician.
There is a defective switch. Contact a qualified electrician.
The fuse blows or
the circuit breaker
trips when the light
is turned on.
The wires are crossed or the
power wire is grounding out.
Check the wire connections.
Contact a qualified electrician or call Commercial Electric customer service
1-877-527-0313.
CAUTION: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or removing the
fuse from the fuse box.
□ Clean the fixture with a soft, dry cloth.
□ Do not use cleaners with chemicals, solvents, or harsh abrasives.
□ Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light fixture.
Care and Cleaning
Troubleshooting
Installation (continued)
Electrical box
A
CC
BB
3
Attaching the housing to the ceiling
□ Drill a 1/8-in. pilot hole into each of the screw locations marked on the ceiling. You can also use an awl or nail to dimple the screw holes.
□ Install a drywall anchor (BB) and a mounting screw (CC) in each drilled mounting hole, but do not tighten fully.
□ Align the 2 mounting keyholes on the fixture body (A) with the 2 mounting screws (CC) in the ceiling. Once
the screw heads are through the large ends of the keyholes, slide the fixture body (A) until the heads of the
mounting screws (CC) slide into the narrow ends of the keyholes.
□ Finish tightening the mounting screws (CC) until the fixture
body (A) is tightly secured to the mounting surface.
NOTE: The drywall anchors (BB)
are only to be used for mounting
the fixture to plaster or drywall
surfaces.