Installation Guide
6
Installation (continued)
4
Selecting the brightness
□ Use the CCT switch (1) on the connector cable to select
3000k, 4000k, or 5000k.
1
5
Installing the junction box and light
panel
□ Insert the junction box (A) through the mounting hole.
□ Push the spring-loaded clips on the light panel (C) upward
and insert the light panel base into the mounting hole.
Release the clips. The light panel (C) will be pulled ush to
the ceiling.
□ For airtight installations, install the foam gasket (B)
between the light panel (C) and the ceiling.
C
B
C
A
A
Care and Cleaning
□ To clean the xture, rst disconnect the power to the xture by turning off the circuit breaker of by removing the fuse at the fuse box.
□ Use a dry or slightly dampened, clean cloth (use clean water, never use a solvent) to wipe the surface of the xture.
□ Allow the xture to dry completely before power is restored.