Instructions / Assembly

2
IMPORTANT SAFETY INSTRUCTIONS
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE NATIONAL ELECTRICAL CODE AND LOCAL BUILDING
CODES BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND
OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.
□ Please read and understand this entire manual before
attempting to assemble, install or operate this light fixture.
□ Save these instructions and warnings
□ This light fixture requires a 120-277V UNV power source. Any
other connection voids the warranty.
□ Fixture should be installed by persons with experience in
household wiring or by a qualified electrician.
□ This light fixture must be properly grounded.
□ Make sure connections are secure using wire nuts, crimp-on
plugs or other UL approved connecting devices.
□ This fixture should be installed outdoors to a wall or a pole.
□ Disassembling your fixture will void the warranty.
□ Always turn OFF the power before adjusting or servicing this
light fixture, wear rubber soled shoes and use a wooden or
insulated(non-grounded) ladder.
□ This product may contain chemicals known to be hazardous.
Thoroughly wash hands after installing, handling, cleaning or
otherwise touching the product.
WARNING: Before installation or servicing, turn the power
OFF at the circuit breaker or fuse. Place tape over the circuit
breaker switch and verify power is OFF at the light fixture.
WARNING: RISK OF FIRE. Keep the lamp heads at least 3
in. (76 mm) from combustible materials.
CAUTION: BURN HAZARD. Allow the light fixture to cool
before touching.
IMPORTANT: This device complies with part 15
Class A of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any
interference received, including interference that may cause
undesired operation.These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment OFF and ON, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for
help.
NOTE: Do not connect this fixture to a dimmer switch.
NOTE: FCC Regulations state that any unauthorized
changes or modifications to this equipment not expressly
approved by the manufacturer could void the user’s
authorization to operate this equipment.
Table of Contents
Safety Information ....................................2
Warranty ............................................3
Pre-Installation .......................................4
Planning Installation .................................4
Tools Required ......................................4
Hardware Included ...................................5
Installation ..........................................6
Operation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
Care and Cleaning ...................................10
Troubleshooting .....................................10
Safety Information