Instructions / Assembly

Installation

Installing double-sided tape

NOTE: If you wish to mount the light with screws, proceed to Step 2.

 Check the location of where you want to place the puck light. Make

sure it is clean and that there is no debris or dust.

 Remove the protective ﬁlm from one side of the double-sided tape (BB)

and apply to the center of the mounting bracket (battery door). Peel off

the remaining protective ﬁlm and press the mounting bracket ﬁrmly to

the intended surface.

Removing the battery cover

 Rotate the battery cover counterclockwise and remove it.

CAUTION: Be cautious of what surface the double-sided tape

is attached to, as it may remove paint or damage the surface.

Mounting with screws

 If previously installed, remove the double-sided tape by pulling the tape

away from the base of the light.

 Rotate the mounting bracket (battery cover) counterclockwise and

remove it.

 Drill two (2) pilot holes in the location where you want to mount the

puck light. Use the mounting bracket as a guide for the pilot holes.

 Place the screws (AA) in pre-drilled holes. Do not over tighten.

 Clip the puck light to the mounting bracket by aligning and inserting the

posts on the bracket into the slots on the backside of the puck light,

then rotating it clockwise to lock in place.