Installation Guide
10
Operation (continued)
2
Pairing Multiple Kits
The remote (C) in each kit comes paired with the tape
light (B). For larger installations, multiple kits can be paired
together for control by a single remote (C).
PAIRING
□ Set to all kits to be paired to the same mode.
□ Unplug the power adapter (A) for the kit that is to be
paired. Wait 5 seconds
□ Restore power to the adapter (A), then within 10
seconds press and hold the red color preset and the RGB
brightness up buttons on the remote (C) at the same time
□ The lights will ash to indicate a successful pairing
This kit will now operate with the remote used in this procedure. Repeat as desired with other kits and remotes.
NOTE: Dynamic effects will not stay synchronized between multiple receivers.
TO RETURN TO SINGLE-REMOTE OPERATION
For each kit, perform the following steps using a unique remote (C):
□ Unplug the power adapter (A) for the kit that is to be returned to single-remote operation.
□ Restore power to the adapter (A), then within 10 seconds press and hold the red color preset and the RGB
brightness up buttons at the same time (The lights will ash to indicate the signal has been received)
□ Perform the two steps above a second time to complete the process
This kit will now operate only using the remote used in this procedure. Repeat as desired with other kits and remotes.
3
Changing the Battery
□ To replace the battery, use the catch at the back to pull the
battery compartment away from the remote.
□ Always purchase the correct size and grade of battery that is
most suitable for the intended use.
□ Ensure the battery is installed correctly with regard to polarity
(+ and -).
□ Remove battery from the equipment when it is not being used
for an extended period of time.
□ Remove used batteries promptly.
WARNING: The remote contains a CR2032 DC 3V button battery. If swallowed, it could
cause severe injury or death within 2 hours. Seek medical attention immediately.
Each remote uniquely
paired to a kit
One Remote pair
ed
to multiple kits