INSTRUCTION MANUAL 2LT Interior Flushmount Twin Pack The Home Depot SKU 442-616 (UPC 6940500313566) (white) The Home Depot SKU 262-063 (UPC 6940500313177) (polished brass) The Home Depot SKU 701-704 (UPC 6940500310633) (brushed nickel) The Home Depot SKU 790-545 (UPC 6940500310640) (nutmeg) Page 1
Thank you for purchasing this Commercial Electric interior flushmount. This product has been manufactured with the highest standards of safety and quality. FEATURES: 1. Two-light interior flushmount in white finish with frosted glass (SKU 442616), polished brass finish with frosted glass (SKU 262-063), brushed nickel finish with frosted glass (SKU 701-704), or nutmeg finish with tea stained glass (SKU 790-545). 2.
CAUTION: 1. Before starting installation of this fixture or removal of a previous fixture, disconnect the power by turning off the circuit breaker or by removing the fuse at the fuse box. 2. CONSULT A QUALIFIED ELECTRICIAN IF YOU HAVE ANY ELECTRICAL QUESTIONS. 3. If you have any non-electrical questions about this fixture, please contact our Customer Service Team at 1-877-527-0313 or visit www.homedepot.com.
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale): 1ea Hex Nut (#5) 1ea Bottom Cover (#8) 1ea Nipple (#6) 1ea Shade (#7) 1ea Finial (#9) ASSEMBLY INSTRUCTIONS: 1. Carefully unpack the fixture. Lay out all parts on a clean surface. 2. Unscrew the Finial (#9) from the Nipple (#6). Screw the Nipple (#6) into the Bushing (#2). Tighten the Hex Nut (#5) against the Bushing (#2) to secure the Nipple (#6). 3. Before continuing Assembly, please proceed to the Installation Instructions. 4.
ASSEMBLY: Page 5
PARTS INCLUDED FOR INSTALLATION (parts are not to scale): 2ea Speed Wire Clips (#11a ,#11b) 1ea Ground Screw (#14) 2ea Outlet Box Screws (#12) 2ea Mounting Screws (#15) 1ea Mounting Strap (#13) 1ea Wire Connector (#16) INSTALLATION INSTRUCTIONS: 1. Screw the two Mounting Screws (#15) into the Mounting Strap (#13). Mount the Mounting Strap (#13) to the Outlet Box (#10) using the two Outlet Box Screws (#12).
INSTALLATION: Page 7
TROUBLESHOOTING: Problem Light bulb will not illuminate. Fuse blows or circuit breaker trips when light bulb is illuminated. Possible Cause 1. Light bulb is burned out. 2. Power is off. Corrective Action 1. Replace light bulb. 2. Make sure power supply is on. 3. Faulty wire connection. 3. Check wiring. 4. Faulty switch. 4. Test or replace switch. Crossed wires or power wire Check wire connections. is grounding out. PRODUCT MAINTENANCE: 1.
MANUAL DE INSTRUCCIONES Plafón para Interiores de 2 Luces de Paquete Gemelo The Home Depot SKU442-616 (UPC 6940500313566) (blanca) The Home Depot SKU 262-063 (UPC 6940500313177) (latón pulido) The Home Depot SKU 701-704 (UPC 6940500310633) (niquel cepillado) The Home Depot SKU 790-545 (UPC 6940500310640) (nuez moscada) Page 9
Gracias por comprar este plafón para interiores Commercial Electric. Este producto ha sido manufacturado con los estándares de seguridad y calidad más altos. CARACTERÍSTICAS: 1. Plafón para interiores de dos luces en acabado en blanca con escarchado (SKU 442-616), en acabado en latón pulido con escarchado (SKU 262-063), en acabado en níquel cepillado con escarchado (SKU 701-704), o en acabado en nuez moscada con tintado en color té (SKU 790-545). cristal cristal cristal cristal 2.
PRECAUCIÓN: 1. Antes de comenzar la instalación o de quitar la instalación anterior, desconecte la alimentación apagando el interruptor del circuito o quitando el fusible en la caja de fusible. 2. POR FAVOR CONSULTE CON UN ELECTRICISTA CUALIFICADO SI TIENE CUALQUIER PREGUNTA ELÉCTRICA. 3. Si tiene cualquier pregunta no eléctrica sobre esta instalación, por favor contacte con nuestro Equipo de Atención al Cliente en el 1-877-527-0313 o visite www.homedepot.com.
PARTES INCLUIDAS PARA EL MONTAJE (las partes no están en proporción de escala): 1ea Tuerca Hexagonal (#5) 1ea Cubierta Inferior (#8) 1ea Entrerrosca (#6) 1ea Pantalla (#7) 1ea Embellecedor (#9) INSTRUCCIÓN DE ASAMBLEA: 1. Desempaquetar cuidadosamente la instalación, disponer todas las piezas sobre una superficie límpia. 2. Desatornillar el Embellecedor (#9) de la Entrerrosca (#6). Atornillar la Entrerrosca (#6) en el Buje (#2).
ASAMBLEA: Page 13
PARTES INCLUIDAS PARA LA INSTALACIÓN (las partes no están en proporción de escala): 2ea Speed Wire Clips (#11a,#11b) 1ea Tornillo de Toma de Tierra (#14) 2ea Tornillos de la Caja de Salida (#12) 1ea Correa de Montaje (#13) 2ea Tornillos de Montaje (#15) 1ea Conectore de Cable (#16) INSTRUCCIONES PARA LA INSTALACIÓN: 1. Atornille los dos Tornillos de Montaje (#15) en la Correa de Montaje (#13).
INSTALACIÓN: Page 15
SOLUCIÓN DE PROBLEMAS: Problema Causa posible 1. La bombilla está quemada. 2. No hay alimentación. La bombilla no se enciende. Cuando se enciende la luz, el fusible se quema o el interruptor de circuito se dispara. Acción Correctiva 1. Reemplace la bombilla. 2. Compruebe si hay suministro de electricidad. 3. La conexión de los cables no es la correcta. 3. Inspeccione el cableado. 4. El interruptor está defectuoso. 4. Pruebe o reemplace el interruptor.
MANUEL D'INSTRUCTIONS 2 Plafonniers d’Intérieur à 2 LM The Home Depot UGS 442-616 (UPC 6940500313566) (blanc) The Home Depot UGS 262-063 (UPC 6940500313177) (bronze poli) The Home Depot UGS 701-704 (UPC 6940500310633) (nickel brossé) The Home Depot UGS 790-545 (UPC 6940500310640) (muscade) Page 17
Nous vous remercions d'avoir acheté ce plafonnier d'intérieur Commercial Electric. Ce produit a été fabriqué en respectant les plus hauts standards de sécurité et de qualité. CARACTERISTIQUES: 1. Plafonnier d’intérieur à une lumière au fini blanc avec un verre gelé (UGS 442-616), un luminaire bronze poli avec un verre gelé (UGS 262-063), fini nickel brossé avec un verre gelé (UGS 701-704), un fini muscade avec un verre teinte ambre (UGS 790-545). 2.
AVERTISSEMENT: 1. Avant de commencer à installer ce luminaire ou d'enlever l'ancien luminaire, déconnectez le courant en éteignant le disjoncteur ou en enlevant le fusible correspondant du coffret à fusibles. 2. CONSULTER UN ELECTRICIEN QUALIFIE QUESTION RELATIVE A L'ELECTRICITE. POUR TOUTE 3. En cas de questions non relatives à l'électricité à propos de ce luminaire, veuillez contacter notre centre de Service à la Clientèle au 1-877-527-0313 ou visiter www.homedepot.com.
PIECES INCLUSES POUR L'ASSEMBLAGE (les pièces ne sont pas à l'échelle): 1x Écrou Hexagonal (#5) 1x Capuchon Inférieur (#8) 1x Manchon Fileté (#6) 1x Abat-jour (#7) 1x Ecrou Décoratif (#9) INSTRUCTIONS D'ASSEMBLAGE: 1. Déballer soigneusement le luminaire. Placer toutes les pièces sur une surface propre. 2. Dévisser l'Ecrou Décoratif (#9) du Manchon Fileté (#6). Visser le Manchon Fileté (#6) sur la Bague (#2). Visser l'Ecrou Hexagonal (#5) sur la Bague (#2) pour maintenir l'Manchon Fileté (#6). 3.
ASSEMBLAGE: Page 21
PIECES INCLUSES POUR L'INSTALLATION (les pièces ne sont pas à l'échelle): 2x Attaches Rapides de Câble d’Alimentation (#11a,11b) 1x Vis de Terre (#14) 2x Vis de Boîte de Sortie (#12) 2x Vis de Montage (#15) 1x Sangle de Montage (#13) 1x Serre-Fils (#16) INSTRUCTIONS D'INSTALLATION: 1. Visser les deux Vis de Montage (#15) sur la Sangle de Montage (#13). Fixer la Sangle de Montage (#13) sur la Boîte de Sortie (#10) grâce aux deux Vis de Boîte de Sortie (#12).
INSTALLATION: Page 23
SOLUTIONS DE DEPANNAGE: Problème L'ampoule ne s'allume pas. Le fusible saute ou le disjoncteur disjoncte lors de l'allumage. Cause Possible 1. L'ampoule est grillée. 2. Le courant est coupé. 3. Mauvaise connexion de fil. 4. Interrupteur mural défectueux. Mauvaise connexion des câbles ou mise à terre défectueuse. Mesure Corrective 1. Remplacez l'ampoule. 2. Vérifiez si le courant est sous tension. 3. Vérifiez le câblage. 4. Testez ou remplacez l'interrupteur. Vérifiez les connexions des câbles.