Installation Guide

Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
2ea Speed Wire Clips (#11a ,#11b)
2ea Outlet Box Screws (#12) 1ea Mounting Strap (#13)
1ea Ground Screw (#14) 2ea Mounting Screws (#15) 1ea Wire Connector (#16)
INSTALLATION INSTRUCTIONS:
1. Screw the two Mounting Screws (#15) into the Mounting Strap (#13). Mount the
Mounting Strap (#13) to the Outlet Box (#10) using the two Outlet Box Screws
(#12). [Make sure the heads of the Mounting Screws (#15) are facing outside when
the Mounting Strap (#13) is attached to the Outlet Box (#10).]
2. Wrap the ground wire from the fixture around the Ground Screw (#14) on the
Mounting Strap (#13), and then connect the ground wire from the fixture to the
ground wire from the Outlet Box (#10). Cover the connection using the Wire
Connector (#16). Connect the white wire (neutral wire) from the Outlet Box (#10)
to the Speed Wire Clip (#11b) by inserting the wire into the open end of the Speed
Wire Clip (#11b) attached to the white wire from the fixture. Connect the black
wire (live wire) from the Outlet Box (#10) to the Speed Wire Clip (#11a) by
inserting the wire into the open end of the Speed Wire Clip (#11a) attached to the
black wire from the fixture. Wrap the
three wire connections with electrical tape for
a more secure connection.
Position the wires back inside the Outlet Box (#10). Note: If
you have electrical questions, consult your local electrical code for approved
grounding methods.
3. Place the Canopy (#1) over the Outlet Box (#10). Allow the heads of the Mounting
Screws (#15) to come out through the large ends of the keyholes on the Canopy
(#1). Twist the Canopy (#1) clockwise until the heads of the Mounting Screws (#15)
slide into the narrow ends of the keyholes. Tighten the Mounting Screws (#15) to
secure the Canopy (#1).
4. Before completing Installation, please return to Assembly Instruction #4.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn
the light switch on to activate the fixture.