Instructions / Assembly

Installation
4
3
Mounting with screws
 Remove the mounting bracket (battery door) so that it can be
used as a template for the screw holes. To do so, slide the light
out of the mounting bracket.
 Drill two pilot holes in the location where you want to mount
the puck light. Use the mounting bracket as a guide for the
pilot holes.
 Place the screws in pre-drilled holes. Don't over tighten.
 Slide the puck light back on to the mounting bracket.
2
Mounting with double-sided tape
NOTE: If you wish to mount the light with screws, proceed to Step 3.
 Check the location of where you want to place the puck light. Make sure it is
clean and that there is no debris or dust.
 Remove the protective film from one side of the double-sided tape (BB) and
apply to the center of the mounting bracket (battery door). Peel off the
remaining protective film and press the mounting bracket firmly to the intended
surface for 5 seconds.
CAUTION: Be cautious of what surface the double-sided tape
is attached to, as it may remove paint or damage the surface.
1
Replacing the batteries
 If the LEDs appear to be dim, this is an indication that your
batteries need to be replaced.
 Slide the puck light out of the mounting bracket and remove it.
 Remove the old batteries and insert three new AAA batteries
(B). Be sure to match the polarity as shown in the diagram in
the battery compartment.
 Replace the mounting bracket.
CAUTION: Do not mix battery types. Use only
fresh batteries. Alkaline are recommended.