Instructions / Assembly

ManualsBrandsCommercial Electric ManualsLandscape LightingLow Voltage Bronze Path Light (4-Pack)

PACKAGE CONTENTS (FOR EACH LIGHT)

A –Lamp Body x1 B – Wire Connector x1 C – Ground Stake (6.693 in.) x1 D – Post x1 E – LED Bulb x1

(with 12 in. wire attached to lamp body)

Installing the bulb

Attaching and installing the light

Step1

□ Use your hand to unscrew the set screws (3) from the top cover (1).

□ Remove the top cover (1) and the shade (2).

Step 2

□ Install the LED bulb (E) by pushing it in until it is secure.

□ Reinstall the shade (2) and then the top cover (1) into place.

□ Use your hand to re-screw the set screws (3) into the top cover (1).

: Never push the fixture into the ground by the lamp body

(A) or use a hammer to insert the ground stake (C) into the ground.

□ Screw the post (D) onto the lamp body (A).

□ Insert the fixture wire on the wire connector (B) into the groove located

on the top of the ground stake (C).

□ Ensure the fixture wire on the wire connector (B) stays in the center of

the groove of the ground stake (C) to avoid damage to the fixture wire.

Screw the post (D) onto the ground stake (C).

□ Prepare a hole in the installation location. Use a tool such as a

screwdriver (sold separately) to prepare the installation hole to ensure

the hole is not larger than the ground stake (C).

□ Install the fixture in the ground by pushing on the foot step (1) on the

ground stake (C). Do not push on the lamp body (A).

Summary of content (3 pages)

PAGE 1
PACKAGE CONTENTS (FOR EACH LIGHT) A –Lamp Body x1 B – Wire Connector x1 (with 12 in. wire attached to lamp body) C – Ground Stake (6.693 in.) x1 2 1 Installing the bulb D – Post x1 E – LED Bulb x1 Attaching and installing the light : Never push the fixture into the ground by the lamp body (A) or use a hammer to insert the ground stake (C) into the ground. Step1 □ Use your hand to unscrew the set screws (3) from the top cover (1). □ Remove the top cover (1) and the shade (2).
PAGE 2
3 □ □ □ □ □ Connecting the wires Place the wire connector (B) on opposite sides of the main low voltage cable (sold separately) from the transformer (sold separately) where the fixture will be located. Align and fit the main low voltage cable horizontally over the slot of the wire connector (B). Press the wire connector (B) together until it is locked around the main low voltage cable. The pre-set prongs will pierce the cable insulation and establish contact with the electrical wire inside.
PAGE 3
□ Clean the fixture with a soft dry cloth. Problem The fixture will not light. The light flickers (one fixture). The lights flicker (all fixtures). □ Do not use any cleaners with chemicals, solvents or harsh abrasives. Possible Cause Solution □ □ There is a loose wire connector to the fixture. □ Check the outlet and ensure that a breaker or GFCI circuit has not been tripped. □ Follow the wires from the fixture and ensure a continuous connected path back to the transformer.