Installation Guide
4
Installation
1
Turning Off the Power
□ Turn the power OFF at the switch and fusebox or
the circuit breaker.
□ Connect the two terminals together. (See Fig. 3)
□ Gently push the trim into place. (See Fig. 4)
□ Remove the existing trim installed in the recessed
housing (if necessary).
□ Install the adapter (AA) into the socket. (See Fig. 2)
2
Removing the Existing Trim
3
Installing the Adapter
4
Connecting the Terminals
5
Securing the Trim
NOTICE: Installation into Existing Recessed Incandescent Fixture:
For use with 4 in. recessed housings (housing sold separately).
LED recessed trim will retrot into select existing 4 in. nominal
incandescent housings.
NOTICE: MIN. LAMP COMPARTMENT DIMENSIONS: 102 mm (4 in.)
DIA X 140 mm (5.5 in.) HEIGHT
AA
Terminals
Clip
Fig. 2
Fig. 3
Fig. 4
WARNING: Risk of re or electric shock. LED Retrot
Kit installation requires knowledge of luminaires electrical
systems. If not qualied, do not attempt installation. Contact
a qualied electrician.
WARNING: Risk of re or electric shock. Install this kit
only in the luminaires that have the construction features
and dimensions shown in the photographs and/or drawings.