Instructions / Assembly

CATII
A
C
F
E
H
G
Completing a Resistance Measurement
4
CATII
A
C
F
E
H
G
Completing an AC Voltage Measurement
3
Completing a DC Current Measurement
2
NOTE: When the value to be
measured is unknown before a
measurement, set the range
selector at the highest position.
Completing a DC Voltage Measurement
1
8 7
HOMEDEPOT.COM
Please contact 1-877-527-0313 for further assistance.
Operation
Connect the red test lead (G) to the
VΩmA jack (F) and the black test lead
(H) to the COM jack (E).
Set the rotary switch (C) to the
desired DCV position.
Connect the red and black test leads
(G and H) across the source or load
being measured.
Read the voltage value on the LCD
display (A) along with the polarity of
the red lead (G) connection.
Set the rotary switch (C) to the desired
DCA position.
Open the circuit in which the current
is to be measured, and connect the
red and black test leads (G and H) in
series with the circuit.
Read current value on the LCD display
(A) along with the polarity of the red
lead (G) connection.
Connect the red test lead (G) to the
VΩΩmA jack (F) and the black test lead
(H) to the COM jack(E). For measurements
between 200mA and 10A, insert the
red test lead (H) into the 10A jack (D).
Operation (Continued)
Set the rotary switch (C) to the
desired ACV position.
Connect the red and black test leads
(G and H) across the source or load
being measured.
Read the voltage value on the
LCD display (A).
Connect the red test lead (G) to the
V ΩmA jack (F) and the black test lead
(H) to the COM jack (E).
Ω
WARNING: If the resistance being
measured is connected to a circuit,
turn off power and discharge all
capacitors before applying the
test leads.
Set the rotary switch (C) to the desired Ω
(omega) range position.
Connect the red and black test leads
(G and H) across the resistor to be
measured.
Read the resistance value on the LCD
display (A).
Connect the red test lead (G) to the
V ΩmA jack (F) and the black test lead
(H) to the COM jack (E).
Ω
CATII
A
C
F
E
H
G
D