Manualshelf

Full Product Manual

ManualsBrandsCommercial Electric ManualsElectricalFull Motion Wall Mount for 13 in. to 47 in. TVs
12345678910
7
Installing the wall mount (wood stud)
Use a commercially-available stud finder to locate the stud centers in the wall. Studs are usually spaced 16 in. apart.
Attach the wall mount (A) to the wall using the lag bolts (CC) and lag bolt washers (BB) as shown.
Use a
3
/
16
in. (4.5 mm) drill bit to slowly drill 2.2 in. (55 mm) pilot holes.
Installing the wall mount (concrete/masonry wall)
6
Use a
1
/
4
in. (6 mm) masonry drill bit to slowly drill 2.4 in. (60 mm) pilot holes. Then use a
3
/
8
in. (10 mm)
masonry drill bit to expand pilot holes.
Use the wall mount (A) as a template to mark the installation holes. Use a level to ensure the wall
mount (A) is level.
Insert anchors (AA) into the holes. Ensure the anchors are completely flush to the concrete surface
even if covered by a layer of joint compound or other material.
Attach the wall mount (A) to the wall using the lag bolts (CC) and lag bolt washers (BB) as shown.
AA
BB
CC
masonry blocks
masonry block.
Installation (continued)