Installation Guide

Installation (continued)
Installing the wall mount (concrete/brick wall)
5
Use the wall mount (A) as a template to mark the installation holes. Use the bubble level (F) to ensure the wall
mount (A) is level.
AA BB CC
Use a 1/2 in. (12 mm) masonry drill bit to slowly drill 3.7 in. (95 mm) pilot holes.
Insert anchors (AA) into the holes. Ensure the anchors are completely flush to the concrete surface
even if covered by a layer of joint compound or other material.
Attach the wall mount (A) to the wall using the lag bolts (CC) and lag bolt washers (BB) as shown.
F
bricks
brick.