-888-526-6193 1-888-526-6193
Table of Contents Safety Information (continued) Safety Information Symbols CAT III Definition (MEASUREMENT CATEGORY III) is applicable to test and measuring circuits connected to the distribution part of the building’s low-voltage MAINS installation.
Safety Information (continued) Pre-Operation FCC Compliance Statement Warranty 1-888-526-6193 4 5 1-888-526-6193
Pre-Operation (continued) GG HH 0.
INCORRECT CORRECT 8 9 1-888-526-6193
200m Completing a Battery Voltage Measurement 10A Insert the RED test lead to VΩ socket C and BLACK test lead to COM socket D , and rotate function knob switch B to 1.5V or 9V battery test setting. 10A A 20m MISUSE CAN RESULT FUSE BLOWN 2m B Connect BLACK test lead to negative and RED test lead to positive terminal of battery. 2M 200k Black Test Lead 10A AC Voltage Measurement (≤600V) 9V 1.
Insert the RED test lead to VΩ socket C and BLACK test lead to COM socket D , and rotate function knob switch B to the highest Ω setting (2MΩ). Insert the RED test lead to VΩ socket C and BLACK test lead to COM socket D , and rotate function knob switch B to ( ) setting. B De-energize the circuit. Measure resistance by connecting test lead to object and rotate the function knob switch B to lower range Ω to receive highest resolution measurements.
Insert the RED test lead to VΩ socket C and BLACK test lead to COM socket D , and rotate function knob switch B to ( ) setting. DC Current less than 200mA B For mA DC Current less than 200mA, Insert the RED test lead to VΩ socket C B De-energize the circuit For continuity measurement by connecting conductor or circuit with test leads. If resistance is measured less than 40Ω, an audible signal will sound and display will show a resistance value. If circuit is open, display will show “OL”.
Battery Replacement When ( ) indicator is displayed on LCD, batteries must by replaced. Remove screw from battery door Replace 2 x AAA batteries (Note proper polarity) + + - - Replace battery cover and secure with screw. Fuse Replacement Fuse may blow if more than 200mA is applied to theVΩ socket C ,more than 10A is applied to the 10A socket E , or Voltage has applied to function with current setting.
18 19 1-888-526-6193
