Installation Guide

7 HOMEDEPOT.COM

Please contact 1-844-548-3776 for further assistance.

Installation (continued)

Hanging the mounting base to the

mounting plate

Junction Box Mount

□ Push the three wires through the grommet (H) in the

mounting base (D) and hang the xture by attaching the

mounting base (D) on the mounting plate (G).

□ Tighten the two mounting bolts (E) removed earlier to

attach the mounting base (D). (Fig. 1)

NOTE: If the wires from the junction box are not

long enough to push through the holes in the wiring

grommet (H), open the xture by loosening the screws

mounting base (D). Now thread the wires from the

junction box through the center hole of the base (D)

into the xture and hang the xture on the mounting

plate (G). Thread the wires from the junction box into

the grommet holes from inside of the xture and then

plug the grommet (H) into the center hole again.

Surface Conduit Mount

□ Remove the conduit entry plug (B) on the side of the

mounting base (D).

□ Thread the wires through the surface conduit entry on

the side of the mounting base (D)and hang the xture by

attaching the mounting base (D) on the mounting plate (G).

□ Tighten the two mounting plate bolts (E) removed earlier

to attach the mounting base (D) on the mounting plate (G).

(Fig. 2)

Fig. 1

Fig. 2