Instructions / Assembly

7 HOMEDEPOT.com
Please contact 1-877-527-0313 for further assistance.
Keyhole Installation (continued)
4
Mounting the fixture through
drywall
□ If the mounting holes go through drywall
without a stud, drill a small pilot hole with
1/8" drill bit (not included) and install wall
anchors (DD) into the holes with a hammer
(not included). Install the four wood screws
(CC) into the mounting surface, leaving an
approximate 3/8"gap between the screw head
and the mounting surface.
Drywall
DD
CC
5
Mounting the fixture to a wall
stud
□ If the mounting holes align with wall studs,
drill a pilot hole using a 5/32" drill bit (not
included) for the wood screws (CC).
□ Install the four wood screws (CC) into the
mounting surface leaving an approximate
3/8"gap between the screw head and
mounting surface.
Wall stud
CC
6
Connecting the wires
□ Before wiring, temporarily connect the male
and female quick connectors (1) to determine
the placement of the black and white power
supply wires. Then, separate the quick
connectors. At the junction box, push the
black power supply wire into the connection
slot on the female quick connect on the side
that will marry to the black side of the male
quick connect. Push the white wire into the
remaining slot.
□ On the xture (A), remove the wire sheathing
from the end of the green wires in order to
expose the copper wires. Twist the green wire
to the corresponding ground wires (GREEN to
GREEN) in the junction box and secure using
the included wire nut (BB).
□ Reconnect the male and female quick
connects ensuring they are rmly seated.
□ OPTIONAL: Wrap connected wire nuts with
electrical tape.
BB
A
1