Instructions / Assembly
2
Table of Contents
Table of Contents ................................... 2
Safety Information .................................. 2
Warranty .......................................... 3
Pre-Installation ..................................... 3
Tools Required .................................... 3
Hardware Included ................................. 3
................................. .
3
Surface Mounting
Specification
.................................
4
Recessed Mounting Including Junction Box
.............
7
Linking Feature
..................................
11
Safety Information
For your safety, always remember to:
□ Turn off the power supply at the fuse or circuit breaker box
before you install the fixture.
□ Ground the fixture to avoid potential electric shocks and to
ensure reliable starting.
□ Double-check all connections to be sure they are
tight and correct.
□ Wear rubber soled shoes and work on a sturdy
wooden ladder or berglass ladder.
□ Account for small parts and destroy packing material, as these
may be hazardous to children.
WARNING: RISK OF SHOCK. House electric current can
cause painful shock or serious injury unless handled properly.
WARNING: Deviation from the assembly instruction may
result in a risk of re or electric shock.
Connect up to a maximum of 8 strip lights. Do not exceed
167 total watts for interconnected lights.
CAUTION: Turn off the main power at the circuit breaker
before installing the fixture, in order to prevent possible shock.
NOTICE:
NOTICE:
All electrical connections must be in accordance with local
and National Electrical Code (N.E.C.) standards. If you are unfamiliar
with proper electrical wiring connections obtain the services of a
qualified electrician.
Remove the fixture and the mounting package from the box and make
sure that no parts are missing by referencing the illustrations on the
installation instructions.
FCC STATEMENT
THIS FIXTURE IS DESIGNED FOR USE IN A CIRCUIT PROTECTED BY A
FUSE OR CIRCUIT BREAKER.THIS PRODUCT MUST BE INSTALLED BY
A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF
THE PRODUCT AND THE HAZARDS INVOLVED. IN ACCORDANCE WITH
THE APPLICABLE INSTALLATION CODE.
KEEP THESE INSTALLATION INSTRUCTIONS.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required to correct the interference at his own
expense.
NOTE: Any changes or modications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.