Installation Guide

4
Pre-Installation (continued)
ENSURING WALL STABILITY
Carefully inspect the wall area you have selected. Examine the wall surface before you begin drilling.
WARNING: Do not drill near electrical wiring and water pipes.
CAUTION: Wood studs must be no smaller than 2 x 4 in. in size. Ensure the surface covering does not exceed 5/8 in.
CAUTION: Concrete walls must have a minimum thickness of 5.5 in. Ensure the surface covering does not exceed 3/8 in.
CAUTION: Do not install this product on a concrete block.
□ For concrete walls, check for damaged or loose concrete and do not drill in those areas.
□ For brick wall, never drill into the mortar between blocks.
□ For wood studs, locate the wall studs and drill in the center of the stud.
TOOLS REQUIRED (NOT INCLUDED IN THE PACKAGING)
Power drill
5-32 in. (4 mm)
wood drill bit or
3/8 in. (10 mm)
masonry drill
bits
Phillips
screwdriver
Stud  nder
Measuring
tape
Pencil Hammer