002 212 025
Table of Contents Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Safety Information Before you begin, carefully read and understand the instructions in this manual.
Warranty The manufacturer warrants that it will replace or repair this item, free of charge, at the manufacturer’s sole discretion, should it prove defective in materials or workmanship.
Pre-Installation (continued) ENSURING WALL STABILITY Carefully inspect the wall area you have selected. Examine the wall surface before you begin drilling. WARNING: Do not drill near electrical wiring and water pipes. CAUTION: Wood studs must be no smaller than 2 x 4 in. in size. Ensure the surface covering does not exceed 5/8 in. CAUTION: Concrete walls must have a minimum thickness of 5.5 in. Ensure the surface covering does not exceed 3/8 in. CAUTION: Do not install this product on a concrete block.
Pre-Installation (continued) HARDWARE INCLUDED NOTE: Hardware not shown to actual size. NOTE: The hardware included is suitable for mounting to walls made of brick, solid concrete, or wood studs covered with drywall. If your mounting situation is different, please consult a qualified installer or contact customer service at 1-877-527-0313 or visit www.HomeDepot.com.
Installation 1 2 Identifying the bolt diameter to use □ Insert a straw or toothpick into one of the mounting holes on the back of your TV. If your TV is curved or recessed, place the proper sized spacer (EE or FF) on top of one of the mounting holes first. To ensure proper mounting of the brackets to your TV, this mounting system includes several sizes of bolts (CC and DD), washers (GG and HH), and spacers (EE and FF) that can be used in various combinations.
Installation (continued) 5 Drilling mounting holes in concrete/ brick wall 6 Drilling mounting holes in wood studs CAUTION: Avoid drilling near electrical wiring and water pipes. The mounting system must be attached to a weight bearing wall and must be installed directly onto the center of the wood studs. Failure to observe all safety precautions can result in serious physical injury and/or property damage. Consult a professional installer or call customer service if you have any questions.
Installation (continued) 8 Attaching the mounting plate to the TV (VESA 100 and 200) A CC GG/HH NOTE: If the back of the TV is not flat, or the bolts are too long, or there is interference between the TV bracket and cable inlets, we strongly recommend the use of spacers. This procedure describes how to attach the mounting plate to VESA 100 and 200 TVs. For VESA 300 and 400, proceed to step 9. □ If necessary, align spacers (EE) or (FF) over the mounting holes on the back of your TV.
Installation (continued) 10 Attaching the TV to the wall plate unit 11 Adjusting the handle □ Turn the handle clockwise until it stops (Fig. 1), and pull the handle out from the wall mount (Fig. 2). CAUTION: Use two or more people to complete this step. □ With the handle pulled out of the wall mount, turn the handle counterclockwise (Fig. 3). □ Align the wall plate (A1) with the end of the wall plate unit (A2) and slide the tab (1) on the wall plate (A1) onto the top edge of the wall plate unit (A2).
Questions, problems, missing parts? Before returning to the store, call Commercial Electric Customer Service 8 a.m. - 7 p.m., EST, Monday-Friday, 9 a.m. - 6 p.m., EST, Saturday 1-877-527-0313 HOMEDEPOT.COM Retain this manual for future use.
