User manual

7. Advanced System Operation

CommPact User Manual

Audio Volume

To adjust the sensitivity of the microphone and the volume of the speaker:

1. Establish a two-way audio connection.

2. During the two-way audio session, from the Service menu, select Audio

Volume [708].

3. Adjust the setting according to the following table.

Reading

Meaning

1 Increase microphone sensitivity

4 Reduce microphone sensitivity

3 Increase speaker volume

6 Reduce speaker volume

87BDisplay Version

To display the system’s software version:

• From the Service menu, select Version [710]; the software (SW) is

displayed.

88BEnable Programming

The installer or the Central Station are able to establish remote connection to the control

system (using regular telephone, cellular communication, or through the Internet) in

order to check the system status, program the control system, and change its settings.

If Installer Access is programmed as "user initiated" the installer or the Central Station

cannot access the control system unless the Master User grants access with Enable

Programming command.

To give access to programming:

• From the Service menu, select Enable Prog. [711]; a 30-minute time

window is opened during which the Installer or RP gain access to the

control system programming.

89BGlobal Chime

Each detector can be programmed by your installer to cause the system to chime when

activated. This feature is active only when the system is disarmed. For example, the

system can be programmed to sound a chime each time the front door is opened or

closed. The Global Chime option enables you to turn this feature on and off.

To enable or disable Global Chime:

1. From the Service menu, select Global Chime [712].

2. Select either Enable or Disable.

Global Chime can also be accessed via a convenient shortcut without needing to

enter a valid user code. To access the Global Chime option from Standby mode,

press

 then .