User Manual

Chapter 7 ● Installing modules
112 Release 2.0, 910056 Rev01d
3. Gently press one end of the cable to the PA’s RF connector.
4. Gently press the other end of the cable to the RM RF connector.
5. Use the small slotted screwdriver to tighten both screws on both connectors to secure the ends of the
cable into the module connectors.
Tighten snugly but do no over tighten or you can strip the threads.
This procedure is complete. Go to Connecting the Sector Radio Kit to the Antenna Interface Unit
on
page 113.
PA
RM
PA RF connector
RF cable
RM RF connector