User Manual

Appendix C ● Using access panels
204 Release 2.0, 910056 Rev01d
Removing the power terminal access panel
This procedure explains how to remove the power terminal access panel.
Requirements
• 5/32 inch tamper-resistant hex drive screw driver.
To remove the power terminal access panel:
1. Open the front door.
See Opening the door
on page 198.
2. Locate the power terminal access panel on the cabinet.
3. Use the 5/32 inch tamper-resistant hex driver to remove all screws from the access panel.
Each screw has a rubber, sealing lock washer on its shank.
4. Carefully set aside the access panel and the screws with their rubber washers.
You will use these to reinstall the panel.
This procedure is complete.
CAUTION
Access panels must be handled carefully. If they are bent they
may not form a proper seal with the cabinet when they are
re-installed. An intact seal on the inside edge of the access panel
is required to ensure external environmental conditions are sealed
out.
Power terminal access panel
Front view, door open