User Manual

Chapter 7 ● Installing modules
114 Release 2.0, 910056 Rev01d
3. For each sector, thread the cable bunch between the cabinet housing and the chassis.
Bring the cable bunch back in front of the modules just above the horizontal cabinet frame piece.
• If you are installing the alpha or beta sector, thread the cable bunch to the left.
• If you are installing the gamma sector, thread the cable bunch to the right.
4. For each sector, hand attach the three sector cables to the appropriate connectors on the RM and PA
modules according to their labels.
• Connect the TX cable to the PA TX connector.
• Connect the RX0 cable to the RM RX0 connector.
• Connect the RX1 cable to the RM RX1 connector.
NOTE
• The cables must be attached to the correct connectors
of the equipment will not work. Also, the AIU’s
sector cables must be attached to the correct Sector
Radio Kits.
• The three connectors on the beta sector are in
different locations than is shown in the left half of the
following figure. For the beta sector, the top left
connector is RX0, the top right connector is TX, and
the bottom connector is RX1.
Alpha and beta sector
cables threaded through
cabinet housing
Gamma sector
cables