User Manual

Connecting the Sector Radio Kit to the Antenna Interface Unit
IP-RN 8000 Installation & Commissioning Guide 115
5. For each sector, tighten all cable connections.
a. Using a 5/16 inch open-ended torque wrench set to seven inch-pounds, tighten the three cable
connections to the RM and PA.
b. Using a 13/16 inch open-ended torque wrench set to seven inch-pounds, tighten the three cable
connections AIU.
6. If you are not deploying any of the three sectors, remove the sector’s cables from the AIU and save
them or dispose of them properly.
This procedure is complete.
• If you have not completed installation of all Sector Radio Kits in this node, you must repeat these
procedures for the next Sector Radio Kit. go to Installing a Power Amplifier
on page 105.
• If you have completed installation of all Sector Radio Kits in this node, go to Installing a Timing
Frequency Unit on page 116.
Sample
RX0 RX1
RX0 RX1
TX Sample
TX
RX1
RX0
TX
PA module
RM module
AUI