User Manual

Installing a Base Input Output/System Controller
IP-RN 8000 Installation & Commissioning Guide 121
4. Gently push the BIO/SC until it touches the backplane.
5. Simultaneously, close the latches and hand tighten the top and bottom captive screws.
6. Use a slotted screwdriver to tighten the two captive screws to secure the BIO/SC module into the
chassis.
Tighten screws snugly. Do not overtighten them or you might strip the threads.
This procedure is complete. Go to Installing a 1xDOM
on page 122.