User Manual

Chapter 7 ● Installing modules
104 Release 2.0, 910056 Rev01d
Understanding the module installation process
This process explains all steps and procedures to follow when installing modules into the cabinet.
1. Installing Sector Radio Kit(s)
These procedures explain how to install the two modules in a Sector Radio Kit. Repeat the procedures
in this section for each sector in your installation. Typical installations support three sectors, but one or
two sector installations are possible. In addition, several cable connections need to be made involving
the Radio Module, the Power Amplifier module and the Antenna Interface Unit for each sector. Follow
these steps for each Sector Radio Kit you install:
a. See Installing a Power Amplifier
on page 105.
b. See Installing a Radio Module
on page 108.
c. See Connecting the RM to the PA with the RF cable
on page 111.
d. See Connecting the Sector Radio Kit to the Antenna Interface Unit
on page 113.
2. Installing Digital Module Kit(s)
These procedures explain how to install the three modules in a Digital Module Kit.
• If you are installing a non-redundant node, follow these procedures once for the primary Digital
Module Kit.
• For redundant installations, follow these procedures twice, once for the primary Digital Module Kit
and once for the redundant Digital Module Kit.
a. See Installing a Timing Frequency Unit
on page 116.
b. See Installing a Base Input Output/System Controller
on page 119.
c. See Installing a 1xDOM
on page 122.
This procedure is complete. You must power the system on. Go to Powering the node
on page 126.