User Manual

Chapter 10 ● Establishing CLI connections
136 Release 2.0, 910056 Rev01d
7. Launch the terminal emulation program.
You can use HyperTerminal, which comes with windows, or any terminal emulation program of your
choice.
8. Open a terminal connection as appropriate for the terminal emulation software.
9. Configure the terminal connection parameters as shown in Table
.
10. Press <ENTER> on the laptop.
The CLI command prompt displays as follows:
AIRVANA-03>
This procedure is complete.
Table 22 Terminal settings for CLI/serial connection
Setting Value
Terminal emulation type VT220 or VT100
Bits per second (BAUD) 38400
Data bits 8
Parity
None
Stop bits 1
Flow control
None
NOTE
If you are establishing CLI/serial connection the craft serial ports
on the RM or TFU modules, you must set the Bits per second to
112500.