User Manual

Chapter 12 ● Running the commissioning script
154 Release 2.0, 910056 Rev01d
Verifying the script file is on the node
This procedure explains how to verify the script file has been transferred successfully to the node and how to
leave the command shell.
1. Look at the CLI output.
If the kermit file transfer failed, an error message displays. If it has failed, attempt the transfer again by
going to Initializing the node to receive a file with kermit
on page 147.
2. Check the contents of the disk0:/config directory with the ls command to see whether the script file is
present as follows:
AIRVANA-03(shell)(disk0:config)>ls
The list of files in the directory is displayed with the size of each file. Ensure the script file you
transferred is present and has a file size greater than 0.
Note that the file name is the name you entered in the CLI command kermit receive
<filename>, not the file name of the file before it was transmitted from the laptop.
If the file is not present, attempt the transfer again by going to Initializing the node to receive a file with
kermit on page 147.
3. Use the exit command to leave the command shell and return to the normal CLI prompt, as follows:
AIRVANA-03(shell)(disk0:config)>exit
The following prompt displays:
AIRVANA-03>
This procedure is complete. Go to Running the script
on page 155.