User Manual

Chapter 7 ● Installing modules
108 Release 2.0, 910056 Rev01d
Installing a Radio Module
This procedure explains how to install a Radio Module (RM).
Be sure you have read and understood Understanding the module installation process
on page 104 before
continuing.
Requirements
•ESD wrist strap
• Slotted screwdriver
Procedure
1. Locate the slot into which you will install the RM module.
The RM installs in the bottom part of slots 1, 5, and 9.
See Understanding module slot numbering
on page 11 for more information.
WRIST
STRAP
Wear an ESD strap and plug it into the ESD jack in the AIU when
handling modules or equipment damage can occur. See Figure 9
on page 18.
CAUTION
Ensure that you install the RM module into the proper slot (either
slot 1 bottom part, slot 5 bottom part, or slot 9 bottom part).
Installation into a slot reserved for a different module type can
cause equipment damage.