User Manual

Entering diagnostic mode and configuring test parameters
IP-RN 8000 Installation & Commissioning Guide 163
This procedure is complete. Go to Entering diagnostic mode and configuring test parameters on page 163.
Entering diagnostic mode and configuring test parameters
This procedure explains how to initiate a hard reset and use the CLI to enter diagnostics mode, and how to
configure the diagnostics mode for E1 links, if E1 backhaul links are deployed (see step 4
). It is assumed
that you already have a CLI link to the node through the serial port on the active BIO/SC module. (See
Establishing the CLI/serial connection
on page 135.)
Requirements
No tools or materials are required.
Procedure
1. Ensure the CLI session is active by pressing the <ENTER> key on your CLI laptop. A new command
prompt appears indicating the session is active.
If the session is not active, see Establishing the CLI/serial connection
on page 135.
2. Use the reset command to reboot the node as follows:
AIRVANA-03>enable
AIRVANA-03#reset
This causes the node to reboot and to run hardware diagnostics.
After hardware diagnostics run, a diagnostics countdown occurs. This countdown enables you to enter
diagnostics mode by pressing the <SPACE BAR> key three times during the countdown. The
countdown numbers are transmitted out the serial port and are visible in your CLI session.
3. During the countdown, press any the <SPACE BAR> key three times .
This causes the RN to enter diagnostics node. Loopback test commands are only available in
diagnostics mode. The diagnostic mode command prompt is”
BIOSC_3>
Where β€œ3” is the slot number.
4. If the backhaul links are E1, enter the following three commands to configure the E1 diagnostic mode:
BIOSC_3>writeee 7FF 02
BIOSC_3>writeee 100 0
BIOSC_3>reset
Resetting the node causes another reboot. You must enter the diagnostics mode by pressing the
<SPACE BAR> key three times during that countdown as you did in step 3
in order to stay in
diagnostics mode and to continue with loopback testing.
This procedure is complete. Go to Performing external loopback tests on backhaul links
on page 164.