User Manual

Chapter 7 ● Installing modules
110 Release 2.0, 910056 Rev01d
5. Simultaneously, slowly close the top and bottom latches.
As you close the latches, the RM module is drawn snugly into the chassis. Be sure the RM faceplate
does not overlap the PA module. An overlap prevents proper module seating.
6. Hand tighten the top and bottom captive screws.
7. Use a slotted screwdriver to tighten the two captive screws to secure the RM into the chassis.
Tighten screws snugly, but do not overtighten them or you might strip the threads.
This procedure is complete. Go to Connecting the RM to the PA with the RF cable
on page 111.