User Manual

Disconnecting the laptop
IP-RN 8000 Installation & Commissioning Guide 189
Disconnecting the laptop
This procedure explains how to disconnect the laptop and close it’s front door shelf in preparation for
departure.
1. Unplug the serial cable from the laptop’s COM port and from the BIO/SC module craft port.
2. If the laptop is connected to the node over Ethernet, disconnect all Ethernet cables.
3. Turn the laptop off.
4. Remove the laptop from the front door laptop shelf.
For information about the laptop front door shelf, see Figure 3
on page 5.
5. Close the front door laptop shelf.
See Closing the PC shelf
on page 202.
6. Leave any pertinent notes or documents in the front door document holder.
This procedure is complete.
Preparing the cabinet for your departure
This procedure explains how to prepare the cabinet for the departure of the field technician.
1. Visually examine the cabinet’s interior and exterior from all sides and inspect for:
• Loose cables that might interfere with the front door closing
• Loose modules that should be inserted properly but are not inserted all the way
• Any access panels that are not installed properly
• Loose power or backhaul cables exiting the cabinet that are not properly enclosed in conduit
• Improperly installed conduit
• Loose or dangling antenna cables
• Check the gasket on the inside edge of the front door.
This gasket should be seated properly all the way around.
• Anything out of the ordinary
2. Press in the tech-on-site switch.
See Understanding the tech-on-site switch
on page 36.
TIP
You might want to leave the cable in the document holder on the
inside of the front door. for information about the document
holder, see Figure 3
on page 5.
CAUTION
Failure to ensure the all aspects of the installation were properly
performed before leaving the site can result in damage to the
equipment or service interruption.